| |
| >>Construction: |
Fully
welded R.H.S. finished in industrial acrylic enamel. |
 |
| >>Control
System: |
PLC
8 Station Programmable System for drum lift, polish brush
and cleaning brush actuation.
Manual Control for drum wind, recovery and pressure pumps
|
|
| >>Electrical
System: |
3
Phase 440 volts main supply.
Control System 240 volts 50 Hz.
Maximum power out put draw at full load 9.5 kW
Current drawn < 25 Amps.
Hour meter, remote stop stations (3) fitted as standard.
Installation conforms to IP 56 standards. |
|
| >>Hydraulic
System : |
7.5
kW power pack with 4 axial piston pressure compensated pump,
full filtration, maximum operating pressure 103 bar @ 46 litres
/ minute.
System capacity 120 litres.
Lift rams protected by load holding counter balance valves.
Ram synchronization via divider / combiner valves.
Solenoid actuated control valves. |
|
>>Solution
Pressure
>>System: |
0.75
kW centrifugal pump with 10 micro suction and self-cleaning
pressure filters.
28 spray nozzles.
Maximum operating pressure 2 bar @ 45 litres / minute. |
|
>>Solution
Recovery
>>System: |
1.1
kW diaphragm pump with box type lint filter on suction side;
120 litres / minute capacity.
High density polypropylene recovery tank with 4 stage gravitational
filters.
Removable top covers for clean out.
Solution capacity approximately 850 litres. |
|
| >>Cleaning
Brushes: |
Dual
hydraulic drive 370 mm. diameter polypropylene trim @ 250
RPM. |
|
| >>Polishing
Brushes: |
Quad
hydraulic drive 290 mm. diameter polypropylene trim @ 225
RPM. |
|
>>Warranty:
|
1-Year
unlimited hour warrantee - Extended warrantees available. |
|
| All
specifications subject to change without notice |
|
